CONSOLE INTERFACE
IP Configuration
Use the IP Configuration screen to set the bootup option, or configure the switch’s IP parameters. The screen shown below is described in the following table.
| SMC TigerSwitch 1000 Local Management | ||
|
| < IP Configuration > | |
|
| Interface Type : Ethernet | |
|
| IP Address | : 10.2.13.29 |
|
| Netmask | : 255.255.255.0 |
|
| Default Gateway | : |
|
| IP State | : |
| <APPLY> | <OK> | <CANCEL> |
Use <TAB> or arrow keys to move, other keys to make changes. | |||
|
|
| |
Parameter | Default | Description | |
Interface | Ethernet | Indicates IP over Ethernet. | |
Type |
|
|
|
IP Address | 10.1.0.1 | IP address of the switch you are | |
|
| managing when accessing it over the | |
|
| network. The switch supports SNMP over | |
UDP/IP transport protocol. In this environment, all systems on the Internet, such as network interconnection devices and any PC accessing the switch must have an IP address.
Valid IP addresses consist of four decimal numbers, of 0 to 255, separated by periods. Anything outside of this format will not be accepted by the configuration program.
