Sony RM-AV2100T, RM-VL900T Checking if the code number works

Setting the Code for Preset Audio and Visual Components (continued)

Notes

•If you press a component code number that is not on the table in the supplied “Component Code Numbers”, the Commander beeps and “NG” flashes after you press the ENTER key. If this happens, check the component code number, and try setting again.

•If you don’t input anything into the Commander for over two minutes between each step, the setup procedure will be canceled. To set the code, you must again press % while pressing COMMANDER OFF.

To check which code number is set

Press the DISPLAY key in Step 3 to 5. The code number and “ENTER” appear twice.

Checking if the code number works

1Press the corresponding Component Select button for the component you have set up.

The Commander turns on and the touch-keys appear on the display.

2Power on the component with its power switch.

3Aim the Commander at the component and press the 1 key in the touch-key display.

When the remote control signal is sent,is displayed on the display.

The component should power off.