To use the Commander after assigning other components
Press the reassigned Component Select button. The keys of the new component are displayed and you can use the desired component. Note however that only the original component name is displayed.
(In this example, the display would be like the one below.)
Original component name
Keys for operating a CD player
To reset a Component Select button to its original setting
1While pressing COMMANDER OFF, press the Component Select button which you want to reset.
2While pressing the CHANGE key, press that Component Select button again.
The setting for that Component Select button returns to the factory setting.
3Press COMMANDER OFF.
Note
If you have programmed some signals on any of the keys or buttons with the learning function (page 16) after you reassigned your component, the two steps above only clears the “learned” signals. In this case, perform Step 2 again to reset to the original Component Select button.
You can copy the entire settings of a Component Select button to another Component Select button. The settings of the component code (page 8) and the learned functions (page 16) are copied to a new button.
Note
You cannot copy the settings to a Component Select button for which any learning function has been programmed. (“NG” flashes.)
37
Continued GB