Transferring Data between Remote Commanders (continued)
2Press the m key.
M: Transfer data
m: Receive data
3Press the 1 key.
1:All data of the Commander
2:Data of a Component Select button
4Press the ENTER key.
To receive the data of a Component Select button from another remote commander
3Press the 2 key.
4Press the Component Select button to which want to assign the data.
5Press the ENTER key.
As the data is received, the corresponding component name stays lit. If the all data have been successfully received, the backlight of the display turns off.
Notes
•If the Commander is not ready for receiving the data, press CLEAR key, then EXECUTE key to clear the learned signal on all or one of the Component Select buttons.
•If “NG” appears during data transfer, go back to Step 3 and continue the operation or press COMMANDER OFF to stop the operation. If you continue the operation, you have to set the sending remote commander again to send data.
44
When the data have been received, “TV” and “m” go off. If the data have been successfully received, the backlight of the display turns off.
Notes
•If the Commander is not ready for receiving the data, press CLEAR key, then EXECUTE key to clear the learned signal on all or one of the Component Select buttons.
•If “NG” appears during data transfer, go back to Step 3 and continue the operation or press COMMANDER OFF to stop the operation. If you continue the operation, you have to set the sending remote commander again to send data.
GB