3Press key(s) or button(s) for the desired operation.
If you want to power on the TV, press the 1 key.
4Repeat Steps 2 and 3 and programme the buttons and keys for the series of operations.
In this example, press the following buttons and keys.
5When you have programmed all the keys, press COMMANDER OFF.
Notes
•If you interrupt the procedure at any point for over two minutes, the setting mode ends and the series of commands will be programmed to that point. In this case, clear the programme (page 26) and start again from Step 1 to set the entire programme from the beginning. You cannot continue from where you let off.
•If a SYSTEM CONTROL button has already “learned” a remote control signal (page 38), “NG”flashes and you cannot programme on
this button. Clear the learned contents first (page 40).
•If you change the component code number (page 8) or programme a new signal by learning (page 16) on a key or button that has been programmed in the series of commands of the System Control function, the new signal will be transmitted when you press the corresponding SYSTEM CONTROL button.
•During Setting mode, the RESET key is not displayed and you cannot clear any operation step you have programmed. If you have programmed an incorrect operation by mistake, start again from Step 1.
Tips for programming the System Control functions
The following information helps you to programme a consecutive operation steps.
About the interval between operation steps
You can change the interval between operation steps (page 30).
25
Continued GB