When you teach the signals of an
See the notes on page 39.
To display only the frequently used keys
You can hide keys you do not use. This makes operations even easier to understand, when the components have many keys.
After Step 2 on page 16, while pressing the RESET key, press the key you want to hide (flashing). The pressed key changes to slower flashing and will no longer be displayed during remote control operations.
To display it again, perform the same procedure again.
Note
You can not hide a key which has “learned” any signal.
To change the function display of a key
When you programme a signal for a key, you can select the most suitable function display among all the displays the key has, and set it to the key.
1After Step 2 (page 16), while pressing the Component Select button (VCR1), press the key you want to teach repeatedly.
Each time the key is pressed, the display is changed in order.
2When the desired display appears, release the Component Select button.
3Then follow Steps 4 to 6 (page 17).
Notes
•You can change the display of a key only when you programme it using the learning function. If you want to change the display of the key that has learned a signal, clear the signal first (page 20). Then teach the key again using the above procedure to change its display.
•If you don’t change the display of a key, the default display is used.
•You cannot change the display of the keys
that are not framed with 
(the numeric keys 0 to 9, +10 and ENTER).
19
Continued GB