Example: To programme the input select signal of your amplifier to the CD button

1Place the RM-AV2100T head to head with your component’s remote control.

Remote control of your component

about 5 – 10 cm

 

(2 – 4 inches) away

RM-AV2100T

2While pressing COMMANDER OFF, press PROGRAMME + and 2 +.

“LEARN” appears and all the component names flash.

Note

The name of a Component Select button for which a signal has already been learned stays lit. If you want to programme a new signal for that button by learning, clear the learned signal first (page 34).

3Press the desired Component Select button.

The selected component name stays lit and “LEARN” flashes.

4Press and hold down the button on the component’s remote control (amplifier in this example) until you hear a beep.

(If you release the button before you hear a beep, the signal may not be learned correctly.)

“LEARN” stops flashing and stays lit.

If “NG” flashes on the display

Learning did not succeed. Try Steps 3 and 4 again.

5Press COMMANDER OFF.

33

Continued GB