Notes
•You can programme the System Control functions for a Component Select button on which the
•You cannot programme the System Control functions for a Component Select button for which a signal has been programmed by “learning” (page 32). (“NG” flashes on the display.)
•You can programme a signal for a Component Select button by “learning” (page 32) for which the System Control functions have been programmed. In this case, the System Control function is overwritten and cannot be used. If you clear the “learned” signal on the button, the System Control function is resumed and you can use it again.
•You can programme the
•If you interrupt the procedure at any point for over two minutes, the setting mode ends and the series of commands will be programmed to that point. In this case, clear the programme and start again from Step 1 to set the entire programme from the beginning. You can not continue from where you let off.
•If you change the component code number (page 8) or programme a new signal by learning (page 16) for a key or button that has been programmed with the series of commands of a System Control function, the new signal will be transmitted when you press the corresponding Component Select button.
To clear a System Control function programmed for a Components Select buttons
Example: To clear the programmed commands on the VCR3 button
1While pressing COMMANDER OFF, press 2 + and VCR3.
2While pressing the RESET key, press VCR3.
When the contents of its programme are cleared, “VCR3” stays lit, and the other component names flash.
When you want to set a new programme to this Component Select button, follow Steps 1 to 2 on page 28.
29
Continued GB