1While pressing COMMANDER OFF, press 2 + and 2
The volume control setting of visual components (TV, VCR1,2 and 3, SAT/ CBL, and DVD) changes to the displayed component.
When set to amplifier volume
When set to
TV volume
Notes
•If you have already programmed the 2 or % button of each component any signals by “learning”, the procedure above will not change the function of the 2 and % buttons.
•If you have programmed volume control signals on 2 or % buttons of TV or AMP, you can only use that signal when you select TV or AMP. For other component, the preset volume control signals for TV or AMP (depending on the above setting procedure) will be transmitted. To use the new signals, you need to programme each button for each component by the learning procedure (page 16).
— System Control Functions
With the System Control function, you can programme a series of operating commands, and execute them by pressing just one button.
For example, when you watch a video, a series of operations like the ones below are necessary.
Example:
1Power on the TV.
2Power on the video (VCR 1).
3Power on the amplifier.
4Set the input selector of the amplifier to VIDEO 1.
5Set the input mode of the TV to
VIDEO.
6Start video playback
You can programme up to 16 consecutive operation steps to each of the SYSTEM CONTROL 1, 2 or 3 buttons.
If you have set the System Control function for a Component Select button (page 28), the execution of the programmed commands begins when you press the Component Select button for more than 2 seconds.
While executing the programmed commands, at the same time that each remote control signal is transmitted, the corresponding key is displayed.
23
Continued GB