Using
Operations
— Learning Function(continued)
Notes
•If you do not perform learning steps within two minutes, learning mode ends.
•If you do not perform Step 4 within 10 seconds after Step 3, the display turns back to the display in Step 2. (All the learnable keys flash.) In this case, perform Step 3 again while the display is flashing,
•If “NG” appears while learning, the memory is full. To free memory, clear learned functions from keys that you do not use often (page 20). Then continue the learning steps.
•If you touch a key by mistake in step 4, while pressing the RESET key, press the mistaken key. Then repeat from Step 3 to continue learning.
If the Commander does not seem to be working
If the learned key or button does not operate properly, teach once again. (For example, if the volume becomes very loud after pressing the
2+ button only once, noise may have interfered during the learning procedure.)
If you set a component code after learning a signal
If you have programmed any signal for a key or button using the learning function, that signal will remain assigned to that key or button even after you set a component code.
When you teach the signals for a double cassette deck
Press DECK B/A to select deck A or B.
18
When you teach the REC (record) signal
If you have to press two buttons at the same time (for example, REC and B) to start recording on your cassette deck or VCR, teach the REC signal in one of the following ways.
To operate with two keys on the Commander
In Step 3 (page 17), while pressing the REC key, press the Bkey to display both keys. Then press the two buttons on your component’s remote control in Step 4.
To operate with one key on the Commander
In Step 3 (page 17), press only the REC key. Then press the two buttons on your component’s remote control in Step 4.
When you teach signals to the 2 or % buttons
•If you have programmed any signal on the 2 or % button for components other than TV and AMP using the learning function, that signal will be transmitted only when you select that component.
•If you have programmed any signal on the 2 or % button for TV or AMP using the learning function, that signal will be transmitted only when you select TV or AMP. When you select other components, the preset volume control signals for TV or AMP will be transmitted (for the difference between visual components and audio components, see page 22). To use the learned signal, you need to programme the 2 or % button for each component using the learning function.
GB