Adding an Extra Function to the Component Select Buttons (continued)
To clear the learned function of the Component Select button
1While pressing COMMANDER OFF, press PROGRAM + and 2 +.
2While pressing the RESET key, press the Component Select button which you want to clear.
Notes
•You can programme a signal by “learning” for a Component Select button for which a System Control function (page 28) or the Power-On function (page 31) has been programmed. In this case, the System Control function or the Power-On function is overwritten and cannot be used. If you clear the “learned” signal from the button, the System Control function or the Power-On function is resumed, and you can use it again.
•You cannot programme a System Control function (page 28) for a Component Select button for which a signal has been programmed by “learning.”
•You can programme the Power-On function for a Component Select button for which a signal has been programmed by “learning,” but then the Power-On function cannot be used. If you clear a “learned” signal from the button, you can use the Power-On function.
Turning Off the Power of All Components with the Touch of a Single Button
—System Power-Off Function (for Sony Components only)
When the System Power-Off function is active, you can turn off all Sony components just by pressing the COMMANDER OFF button for three seconds.
Notes
•Some Sony components may not be turned off with this function.
•The power-off signals are transmitted at intervals that are set for the System Control function set for the SYSTEM CONTROL 1 button (page 30). If you change the interval for the SYSTEM CONTROL 1 button, the interval of the System Power-Off function is also changed.
To set the System Power-Off function
