Configure the settings according to the operation environment, and click [Next] for each of the settings screen.

Note

When using the NSR-100/50, connect the following devices to each of the LAN ports. LAN1: Network cameras

LAN2: Remote clients

LAN3: External storage devices (This may not be supported depending on the software version. For details, consult your dealer.)

When using a DHCP server to configure address settings automaticallySelect [DHCP].When configuring addresses manually(1)Select [Static].(2)Enter the following information.IP AddressEnter the desired IP address.

Caution

•Before you enter the desired IP address, make sure that it is not already otherwise used on the network. Entering an IP address already in use may lead to erratic operation of the unit, but no error messages appear to indicate the fact.

•Because of IP address attribution rules, setting an invalid address such as the ones below is not allowed.

Example: 224.0.0.0 to 255.255.255.255 0.0.0.0127.0.0.1, etc.NetmaskEnter the subnet mask address.

Note

The default settings for network devices are as follows.IP Address: 192.168.[0/1/2]*.1

Netmask: 255.255.255.0

*The settings for each of the network devices #1, #2, and #3 (only network device #1 for the NSR-25).

The [Monitor Model] screen appears.

9 Perform screen size settings depending on each monitor port, and then click [Next].

When two monitors are connected, clicking [Dual Head] displays the second monitor configuration screen.

Select the appropriate monitor type and resolution (pixels) for your monitor.

Notes

•The default setting for monitors is as follows. Generic LCD Display; LCD Panel 1600x1200; 31.5-90; 60

Resolution 1024x768

•Most monitors will operate with [Generic Monitor], but you can select [Others] as required.

Caution

When configuring settings for the second monitor, the second monitor must be connected when the NSR restarts. Be sure to connect the second monitor before finishing the configurations.

When using the NSR-100/50, the [Video Setting] screen appears. Proceed to step 10.When using the NSR-25, the [Host Name] screen appears. Proceed to step 11.

18 Initial Operations (Basic Initial Setup)