3 Perform the following settings.5 Perform the following settings.

In the Camera IP Setup window, you can search for cameras on the same network by MAC address and configure their IP addresses all at once.

(1)Select the network to search in the field labeled “1. Select Network Device for IP Setup.” Normally, Network 1 is selected as the camera network, and a list of the cameras found appears in the “Found Camera List.” The check boxes of all found cameras are selected.

(2)Enter the following information in the field labeled “2. Set Camera network setting.”

•The user name and password of the camera you are configuring settings for.

•The range of IP addresses on the same network (default: 0 to 254) for which to perform automatic assignment.

•The http port number (default: 80) forcommunicating with cameras.

*If there is a fixed range of IP addresses that can be assigned to cameras, make sure to specify the correct range.

(3)Click [Set].The information you entered is reflected in the “Found Camera List.”

IP addresses are assigned within the specified range. Because the list does not expand to compensate if there are not enough IP addresses, make sure the list is set correctly by directly changing addresses in the list as needed. At this stage, the settings have not yet been applied to the camera.

(4)Click [Apply].

This configures the camera settings using the information developed in the list.

It takes a few moments for the settings to complete.4 When the settings for each camera are complete, click [Register All].The Register Cameras window appears.

In the Register Cameras window, a list of cameras that have not been registered to the NSR appears with the check box for each selected.

(1)Verify the number of cameras selected for registration in the column labeled “Cameras to be registered”, and confirm the user name and password for each camera.

Note

The user name and password for the cameras are not set by default. You can set the user name and password for the selected cameras all at once under “Register selected Cameras for NSR”.

(2)Click [Register].The selected cameras are registered to the NSR.

*By clicking [Camera IP Setup], you can also return to the previous Camera IP Setup window.

6 When registration is complete, click [Close]. The Configuration window returns to the Camera screen. The registered cameras are listed.

7 If necessary, configure the individual settings for each camera.For details about settings, refer to the supplied user’s guide.

20 Initial Operations (Basic Initial Setup)