4 Use the supplied round head screws to secure the NSR to the rack.

Round head screw

*The remainder of this manual uses illustrations and screens of the NSR-100/50.

Connecting a Monitor

Connect the monitor to the monitor1 connector on the rear of the recorder.

Connecting the Keyboard, Mouseand Remote Control Unit(RM-NS10)

1 Connect the keyboard to the USB connector on the rear (or front) of the recorder.

2 Connect the mouse or the remote control unit (RM-NS10) to the USB connector.

Note

When using the NSR-25, only the two USB connectors on the rear of the unit are available. Connecting a keyboard and mouse makes setting up for the first time easier.

Connecting the Power Cord

1 Connect the power cord to the power supply connector at the rear of the NSR, and then connect the other end to the power outlet.

1

To the power outlet

2 Lift the power cord safety clip and snap it around the power cord to prevent it from disconnecting.

Note

Before installing, carefully read “Important Information About Safety” (page 3). When using more than one NSR, also make sure to have sufficient power capacity.

Connecting the Network Cable

Connect the network cable.

Connect the one end of the network cable to one of the LAN connectors at the rear of the NSR. Connect the other end to the network switch.

14 Installation