Figure 2-4. The paper release lever has two settings: “F” for friction feed and “T” for tractor feed.
for “Tractor Feed” and is used only with
nLoading single sheets
Paper width must always be between 8 and 10 inches (8 and
15 inches for the | - | ||||
| |||||
and .lO mm. |
|
| - | ||
Now, instead of rolling the paper in manua& by turning the | |||||
| |||||
platen | knob, | we’re going to use the L.F. | button, with the power | - | |
switch | turned | on. (This means we’ll have | to use the “F” (friction | - | |
feed) position of the release lever.) Remember what we told you |
| ||||
about that L.F. (line feed) button? This allows you to advance |
| ||||
the paper one line at a time, and if you hold the button down, |
| ||||
you’ll get multiple line feeds, one after the other. |
| ||||
OK? | Now | let’s start. |
|
| |
1.Remove the printer cover and tractor unit (you can leave the paper separator on if you have installed it).
2.Turn the power switch on.
3.Lift up the paper bail bar.
4.Set the release lever to the “F”position.
-
-
14
