Star Micronics SB-15 user manual You Position SD-15 Above the stack of fan-fold Paper

--

-

-

Figure 2-8. SD-lo/l5 ready to run with sprocket-teed paper.

nBottom feeding SD- 15

The SD- 15 can be loaded with sprocket paper in two different											-
ways-either		from the back, as with SD-10,or through a slot in
the bottom.		To load SD- 15 from				the back, follow		the steps shown			-
in the previous			section.		But for	loading	through	the	bottom	slot,
you	position	the		SD-15	above the stack of fan-fold				paper,	with	-
the	paper being			fed up	through	the bottom of		the	printer	and
on	out the	back.									‘d
											-
To use SD-15 this way, you’ll need to install the tractor unit,
and	the paper		separator		if you haven’t		already.	If you’re unsure			-
how to do it, see Chapter 1 and Figure 2-6.
The steps		for		bottom	loading	SD-15.					-

1.Turn the power switch off and remove the printer cover.

2.Pull the release lever to position “T” (Figure 2-4).

3.Raise the paper bail bar.

4.Place the stack of sprocket-feed paper below the printer, ideally on a specially-built printer table with a bult-in slot.

18 -