14 Sun Crypto Accelerator 4000 Board Installation and User’s Guide • May 2003
Installing the Board
Installing the Sun Crypto Accelerator 4000 board involves inserting the board into
the system and loading the software tools. The hardware installation instructions
include only general steps for installing the board. Refer to the documentation that
came with your system for specific installation instructions.

▼To Install the Hardware

1. As superuser, follow the instructions that came with your system to shut down
and power offthe computer, disconnect the power cord, and remove the computer
cover.
2. Locate an unused PCI slot (preferably a 64 bit, 66 MHz slot).
3. Attach an antistatic wrist strap to your wrist, and attach the other end to a
grounded metal surface.
4. Using a Phillips-head screwdriver, remove the screw from the PCI slot cover.
Save the screw to hold the bracket in Step5.
5. Holding the Sun Crypto Accelerator 4000 board by its edges only, take it out of the
plastic bag and insert it into the PCI slot, and then secure the screw on the rear
bracket.
6. Replace the computer cover, reconnect the power cord, and power on the system.
7. Verify that the board is properly installed by issuing the show-devs command at
the OpenBoot™ PROM (OBP) ok prompt:
In the preceding example, the /pci@8,600000/network@1 identifies the device
path to the Sun Crypto Accelerator 4000 board. There will be one such line for each
board in the system.
ok show-devs
.
/chosen
/packages
/upa@8,480000/SUNW,ffb@0,0
/pci@8,600000/network@1
/pci@8,600000/SUNW,qlc@4
/pci@8,600000/SUNW,qlc@4/fp@0,0
.