Sun Microsystems 6800/4810/4800/3800 Setupdomain, 10Parameter Values for the setupdomain Command

setupdomain

Configures the domain.

Scope

domain shell

Syntax

setupdomain [-p part]. . .

setupdomain -h

Options/Parameters

-hdisplays help for this command.

-ppart configures the specified information and has the following options:

■bootparams configures the boot parameter information.

■loghost configures the log hosts

■snmp configures SNMP information.

TABLE 3-10lists the parameter values for setupdomain. Note that for diag-leveldefinition and function of default and max are the same. Because the tests for mem1 and mem2 take a long time to run, use the default or max values. However, if you suspect memory problems, then use the mem1 or mem2 values.

TABLE 3-10Parameter Values for the setupdomain Command

Parameter	Value	Description
diag-level	init	Only system board initialization code is run. No
		testing is done. This is a very fast pass through
		POST.
	quick	All system board components are tested using few
		tests with few test patterns.
	default (default value)	All system board components are tested with all tests
		and test patterns, except for memory and Ecache
		modules. For memory and Ecache modules, all
		locations are tested with multiple patterns. More
		extensive, time-consuming algorithms are not run at
		this level. This is the same as max.

76 Sun Fire 6800/4810/4800/3800 System Controller Command Reference Manual • October 2001