Sun Microsystems 6800/4810/4800/3800 manual Code Example 3-46Variables for the setupdomain Command

Example

CODE EXAMPLE 3-46Variables for the setupdomain Command

schostname:A> setupdomain

Domain Boot Parameters

----------------

diag-level [default]: verbosity-level [min]: error-level [max]: interleave-scope [within-board]: interleave-mode [optimal]: reboot-on-error [false]: OBP.use-nvramrc? [<OBP default>]: OBP.auto-boot? [<OBP default>]: OBP.error-reset-recovery [<OBP default>]:

Log hosts

---------

Loghost [ ]:The hostname or the IP address of the loghost for this domain.

Log Facility [local0]: Defined by the Solaris operating environment syslogd in /etc/syslog.conf.

SNMP

-----

Domain Description[]: A brief description for this domain (its function).

Domain Contact[ ]: The name of the primary domain administrator.

Trap Hosts [ ]: The IP address of the loghost for this domain.

Public Community String [ ]:The community string for SNMP readers.

Private Community String [ ]: The community string for readers and writers.

schostname:A>

Note –The default value displayed by the software for the OBP.* parameters is <OBP default>.

If you enter an invalid value, the system controller displays “invalid entry” and prompts you to enter a proper value (TABLE 3-10). If a value is not specified, it retains its current value. When an invalid entry is entered, it also lists the valid responses. Typing a dash ( - ), clears the entry.

Current values are displayed in [ ]. TABLE 3-10lists the setupdomain parameter values.

80 Sun Fire 6800/4810/4800/3800 System Controller Command Reference Manual • October 2001