TABLE 3-11 setupplatform Parameter Values (Continued)
Parameter | Description |
|
|
Platform Contact
Platform Location
Trap Hosts
Public Community String
Private Community String
ACL for Domain A
ACL for Domain B ACL for Domain C ACL for Domain D SC POST diag level
off
The name of the person who is responsible for this system. This name will be used by SNMP. Note that if SNMP is not going to be enabled, this field is informational only.
Location of the system (such as a room and/or the location inside of the room). This information will be used by SNMP. Note that if SNMP is not going to be enabled, this field is informational only.
IP address or name of the trap hosts (SNMP). You can define multiple trap hosts.
Community string for SNMP readers. The default is
3.0software to access the system controller using SNMP, their community strings should be set to the same value as the value entered here.
Community string for readers and writers. The default is
3.0software to access the system controller using SNMP, their community strings should be set to the same value as the value entered here.
Access Control List (ACL). If the board name is listed in the ACL for the specific domain, then you have permission to perform addboard or deleteboard requests on that board. Default value is to have all slots assigned to all domains.
•Typing the
•Typing a prefix of
•Typing a dash ( - ) clears the entire list.
•Typing a + (plus sign) adds all.
•Pressing the Return key does not change the value displayed inside [ ].
See the description for ACL for Domain A.
See the description for ACL for Domain A.
See the description for ACL for Domain A.
The system controller boot parameters (diag level) can be set to: off, min, or max.
Only system board initialization code is run. No testing is done. POST is not run.
