Sun Microsystems 6800/4810/4800/3800 manual Runs all tests at the default level plus more

TABLE 3-10Parameter Values for the setupdomain Command (Continued)

Parameter	Value	Description
	max	All system board components are tested with all tests
		and test patterns. This is the same as default.
	mem1	Runs all tests at the default level plus more
		exhaustive DRAM and SRAM test algorithms. These
		tests take a long time to run.
	mem2	This is the same as mem1 with the addition of a
		DRAM test that does explicit compare operations of
		the DRAM data. These tests take a long time to run.
verbosity-level	off	No status messages are displayed. POST output is
		always displayed. However, with the value set to
		off, there is very little POST output displayed and
		there may be a long time between output displays.
		This depends on your hardware configuration and
		the setting of diag-level.
	min (default value)	Test names status messages, and error messages are
		displayed.
	max	Subtest trace messages are displayed.
error-level	off	No error messages are displayed.
	min	The failing test name is displayed.
	max (default value)	All relevant error status is displayed.
interleave-scope	within-cpu	The memory banks on a CPU will be interleaved
		with each other. Each CPU may have up to four
		logical memory banks.
	within-board (default	The memory banks on a system board will be
	value)	interleaved with each other.
	across-boards	The memory will be interleaved on all memory
		banks across all of the boards in the domain.
		With this value, you cannot remove a CPU/Memory
		board from the system using DR.
interleave-mode	optimal (default value)	The memory is mixed-size interleaving in order to
		gain optimal performance.
	fixed	The memory is fixed-size interleaving.
	off	There is no memory interleaving.
reboot-on-error	false (default value)	The domain will be paused when the system
		controller detects a hardware error.

Chapter 3 System Controller Alphabetical Command Reference 77