TABLE 3-10Parameter Values for the setupdomain Command (Continued)

Parameter

Value

Description

 

 

 

Loghost

 

The name or the IP address of the loghost for this

 

 

domain (SNMP).

Log Facility

The log facility is defined by the Solaris operating

 

 

environment syslogd in /etc/syslog.conf.

 

 

The default is local0.

Domain

Description

Enter a brief description for this domain. For

 

 

example, its function.

 

 

Enter the name of the primary domain administrator.

Trap Hosts

Enter the name or the IP address of the trap hosts for

 

 

this domain. You can define multiple trap hosts.

Public

Community

Community string for SNMP readers. The default

String

 

value is A-public, B-public, and so on.

 

 

Note—For SNMP clients such as the Sun

 

 

Management Center 3.0 software to access the

 

 

system controller using SNMP, their community

 

 

strings should be set to the same value as the value

 

 

entered here.

Private

Community

Community string for readers and writers. The

String

 

default value is A-private, B-private, and so on.

Note—For SNMP clients such as the Sun Management Center 3.0 software to access the system controller using SNMP, their community strings should be set to the same value as the value entered here.

Description

Configures domain specific values. Configures the domain. You can configure each domain differently and independently This command is an interactive command. You are prompted for parameters to configure.

See Also

password, setdate, showdate, showdomain, and the section “To Configure Domain-Specific Parameters” in the “System Power On and Setup” chapter of the Sun Fire 6800/4810/4800/3800 Systems Platform Administration Manual.

Chapter 3 System Controller Alphabetical Command Reference 79

Page 95
Image 95
Sun Microsystems 6800/4810/4800/3800 manual Name or the IP address of the loghost for this