Coupled
Commands:
SOURce:FUNCtion Subsystem
AM700 Audio Measurement Set Programmer Manual 3–117
SOURce[5–6]:FUNCtion:SHAPe JSINe
Usage: Used to apply jitter to the digital interface signal from the A and B digital
generators (suffix SOURce5 and SOURce6 respectively).
Acts just like sine wave, but puts jitter on the digital interface. The jitter signal
is sinusoidal phase modulation of the digital interface clock.
When jittered sine is selected on either digital source channel it forces the other
channel to also use jittered sine.
Sine-wave amplitude and frequency parameters (SOUR[5–6]:FREQ:CW, etc.)
are still active and may be assigned to be controlled by the Generator
Amplitude and Frequency knobs.
SOUR:JSIN:JFRequency <numeric_value>
SOUR:JSIN:JAMPlitude <mumeric_value>
SOUR:JSIN:JSHape SIN|USER
SOURce[5–6]:JSINe:JFRequency <numeric_value>
Parameters: <numeric_value> Frequency of the jitter signal in Hz.
Range: 11.782 to 50002.277
Resolution: 11.782
Units: Hz.
SOURce[5–6]:JSINe:JAMPlitude <numeric_value>
Usage: Assigns the amplitude value applied to the sine-wave modulation of the digital
interface clock signal.
Parameters: <numeric_value> Amplitude of the jitter signal.
Range: 0.0 to 10.23