Tektronix TDS5000B Series Verifythe Internal Printer (Optional)

Brief Procedures
2-14 TDS5000B Series Specifications and PerformanceVerification
f. Verifythat the oscilloscope retrieved the saved waveform from the disk.
Do this by noticing the horizontalSC ALE is again1 ms and the
waveformshows ten cycles just as it did when you saved the setup.
9. Remove the test hookup:
a. Disconnect the probefrom the channel input and the probe compensation
output.
b. Remove the floppy disk fromthe floppy disk drive, if present.
Equipment
required
Integrated Thermal Printer (Option 1P)
Prerequisites None
1. From the Windowsdesktop, selectS tart>Settings >Control Panel.
2. Open the Printers file.
3. Right-click on the IntegratedThermal Printer icon; then select Properties.
4. Click the General tab.
5. Click PrintTestPage.
6. Verifythat the test page advances through the printer andprints clearly.
Refer to Figure 2--7 on page 2--15for a sample of t he test page.
Verifythe Internal Printer
(Optional)