Tektronix TDS5000B Series TDS5000B Series Specificationsand Performance Verification 2-19, Table2- 1: Test equipment (Cont.)

Performance Tests
TDS5000B Series Specificationsand Performance Verification 2-19
Table2- 1: Test equipment (Cont.)
Item number and
description PurposeExampleMinimum requirements
16. Adapter(three required) SMA female-to-female Tektronixpart number
015-1012-00
Checking the delay between
channels
17. Adapter(three required) SMA male-to-female BNC Tektronixpart number
015-1018-00
Checking the delay between
channels
18. Pulse Generator 250M Hz, ≤1 nsrise time, 5 V out Wavetek95001, 2 UsedtoTestDeltaTime
Measurement Accuracy
19. Cable, Coaxial
(tworequired)
50Ω, 20 in, male-to-male SMA
connectors
Tektronixpart number
174-1427-00
UsedtoTestDeltaTime
Measurement Accuracy
20. Adapter(four required) MaleN-to-femaleBNC Tektronixpart number
103-0045-00
Checking Analog Bandwidth
21. Adapter Female N-to-male BNC Tektronixpart number
103-0058-00
Checking Analog Bandwidth
22. Adapter SMA“T”, male to 2 SMA female Tektronixpart number
015-1016-00
UsedtoTestDeltaTime
Measurement Accuracy
23. Adapter SMA female to BNC male Tektronixpart number
015-0572-00
UsedtoTestDeltaTime
Measurement Accuracy
24. Adapter BNCm ale to female elbow Tektronixpart number
103-0031-00
UsedtoTestDeltaTime
Measurement Accuracy
25. Adapter BNCf emale to clip lead Tektronixpart number
013--0076--00
Usedt o TestProbe
Compensation Output
26. Termination Shortci rcuit, SMA connector Tektronixpart number
015-1021-00
UsedtoTestDeltaTime
Measurement Accuracy
27. Attenuator,2X Ratio: 2X; impedance 50Ω; connec-
tors: female BNC input, male BNC
output
Tektronixpart number
011-0069-02
UsedtoTestDeltaTime
Measurement Accuracy
28. Mouse or keyboard Tektronixpart numbers:
119-6298-xx(mouse)
119-6297-xx(keyboard)
Usedt o input test selections
1Wavetek9500/Option 100 and output head appropriate for the bandwidth of the oscilloscope under test(9520, 9530, 9550).
Warning:This generator can output dangerous voltages. Set the generator to Off or 0 volts before connecting, discon-
necting, orchangi ng any testhookup during all procedures to follow. Also read the Warning statement on page 2- 24.
2ForDelta Time Measurement Accuracy, use a Wavetek 9500 or a pulse generator with a rise time as shown in Table 2-4
on page 2 - 44.
3Warning:The P6243 and P6245 probes that may be used with this oscilloscope provide an extremelylow loading
capacitance(<1 pF) to ensure the best possible signal reproduction. These probes should not be used to measure
signals exceeding ±8 V,or errors in signal measurement will be observed. Above 40 V, damage to the probe may result.
Tomake measurements beyond ±8 V, use either the P5050 probe (good to 500 V), or refer tothe catalog for a recom-
mended probe.