www.ti.com

Appendix A

Link — The transmission path between any two instances of generic cabling.

Multicast MAC Address — A class of MAC address that sends a packet to potentially more than one recipient. A group address is specified by setting the LSB of the first MAC address byte to 1. Thus, 01h-02h-03h-04h-05h-06h is a valid multicast address. Typically, an Ethernet MAC looks for only certain multicast addresses on a network to reduce traffic load. The multicast address list of acceptable packets is specified by the application.

Physical Layer and Media Notation — To identify different Ethernet technologies, a simple, three-field, type notation is used. The Physical Layer type used by the Ethernet is specified by these fields:

<data rate in Mb/s><medium type><maximum segment length (×100m)>

The definitions for the technologies mentioned in this document are in Table A-1.

 

Table A-1. Physical Layer Definitions

Term

Definition

10Base-T

IEEE 802.3 Physical Layer specification for a 10 Mb/s CSMA/CD local area network over two pairs of

 

twisted-pair telephone wire.

100Base-T

IEEE 802.3 Physical Layer specification for a 100 Mb/s CSMA/CD local area network over two pairs of

 

Category 5 unshielded twisted-pair (UTP) or shielded twisted-pair (STP) wire.

Twisted pair

A cable element that consists of two insulated conductors twisted together in a regular fashion to form a

 

balanced transmission line.

Port — Ethernet device.

Promiscuous Mode — EMAC receives frames that do not match its address.

118

Glossary

SPRU941A –April 2007

Submit Documentation Feedback

Page 118
Image 118
Texas Instruments TMS320DM643X DMP manual Table A-1. Physical Layer Definitions, Term Definition