1 TROUBLESHOOTING FOR THE HARDWARE
Receiving tray lower cover
1Separate the Finisher from the equipment when it is installed.
1)Open the front cover of the Finisher when the Hole Punch Unit is not installed. Open the Hole Punch Unit cover when the Hole Punch Unit is installed.
2)Pull the knob to unlock the Finisher.
When the Hole Punch Unit is not installed
1 | 2 |
When the Hole Punch Unit is installed
2 |
1 |
3) Move the Finisher until it stops placing your hands on the positions shown in the figure.
When the Hole Punch Unit is not installed | When the Hole Punch Unit is installed |
2 Open the cover under the receiving tray and remove the jammed paper.
3 Close the cover.
4 Close the covers of the Finisher and the Hole Punch Unit (when it is installed) first, and connect the Finisher to the equipment.
Move the Finisher slowly placing your hands on the positions shown in the figure.
Be careful not to let your fingers be caught between the
Finisher and the equipment
