Toshiba GD-1060 manual Sending Originals Direct TX, Direct TX by Default Setting

9. SENDING ORIGINALS (DIRECT TX)

2

•When you have placed the originals and performed the sending operation, the remote FAX is immediately dialed, and originals are sent after connecting with the remote FAX with each page scanned separately.

•You can check immediately if the original has been sent to the remote FAX.

•Once scanned, originals are not stored in the memory.

•Operation methods are different depending upon whether the originals are placed on the original feed tray or they are placed on the original glass.

•After a page has been sent, the next page is scanned. This may increase the amount of time required to scan all pages.

Direct TX by Default Setting

•Make sure that direct TX is set as the transmission mode in the PROGRAM menu. ( See page 4-26.)

•The factory setting is memory TX.

•In the direct TX mode, you cannot specify two or more remote FAXes at one time.

Tip

•When direct TX is set using the transmission mode settings in the PROGRAM menu, all subsequent transmissions are in the direct TX mode.

1 Press the key.

2 Place the original.

•For details on how to place the originals on the original glass.

( See page 2-8.)

3 Set the scanning conditions.

( See pages 2-10 to 2-15.)

4 Dial the remote FAX number. ( See pages 2-16 to 2-21.)

•A group cannot be designated as a remote FAX number.

DIALING

JOB NUMBER : XXX

12345

•If the remote FAX is busy, the Message Display shown to the right is displayed.

Line busy

FEB25-2001 11:30AM M :100%

RESOLUTION:STANDARD :AUTO

COMM.OPTION

•If the transmission fails, the Message Display shown to the right is displayed and the job is cancelled.

Communication error FEB25-2001 11:30AM M :100%

RESOLUTION:STANDARD :AUTO

COMM.OPTION

•Once connected to the remote FAX, the Message Display shown to the right displayed.

2-24BASIC OPERATION

TRANSMITP001

JOB NUMBER : XXX

EC SUPER G3

12345