Toshiba R-TH10 A1.3.3 Detection Area of the Reflective Sensor, A1.3.4 Effective Print Area

APPENDIX 1 SPECIFICATIONS EO1-33032

A1.3 Media

A1.3.3 Detection Area of the Reflective Sensor

The reflective sensor is movable from the center to the left edge of media.

The reflection factor of the black mark must be 10% or lower with a waveform length of 950 nm. The reflective sensor should be aligned with the center of the black mark.

Sensor should be positioned at the center of the black mark.

2 to 20 mm

Min. 12 mm

Center of media

Detecting the black marks on the back.

Media feed direction

Sensor is movable within this range.

A1.3.4 Effective Print Area

The figure below illustrates the relation between the head effective print width and media width.

Out of print range		Print Head Element			Out of print range
2.7		104.0 mm ± 0.2 mm	2.7
	mm	(Head Effective Print Range)		mm

112.0 mm (Maximum paper width)

The figure below shows the effective print area on the media.

Area to be detected.

Start line

1.5mm from the left edge of media

1 mm
Guaranteed print area	1.5 mm from the right
	edge of media
1 mm	Media feed direction
	Area to be detected.
Media width
(backing paper width is not included.)

NOTES:

1.Avoid printing in the area 1.5-mm wide from the media edges (shaded area in the above figure).

2.The center of media is positioned at the center of the print heads.

3.Print quality is not guaranteed within 3 mm from the print head stop position (including 1-mm slowup).

4.Average print (black) rate should be 15% or less. For bar code print area, the print rate should be 30% or less.

5.Line weight should be 3 to 12 dots.

A1- 4