2. PRINTER SETUP |
2.8 Loading the Ribbon
2.8 Loading the Ribbon
WARNING!
1.Do not touch any moving parts. To reduce the risk of fingers, jewellery, clothing, etc. being drawn into the moving parts, be sure to load the ribbon once the printer has stopped moving completely.
2.To avoid injury, be careful not to trap your fingers while opening or closing the cover.
3.Be sure to open the top cover fully, otherwise the top cover may close, causing injury.
1.Grasp the tabs on the top and bottom of the ribbon stoppers and move the ribbon stoppers back to the end of the shaft.
Ribbon Stopper
2.Leaving plenty of slack between the ribbon spools, place the ribbon onto the ribbon shafts as shown below. When the ribbon is fitted, it must be positioned in the ribbon sensor.
Ribbon Shafts
NOTE:
The ribbon sensor is mounted on the rear of the printer block to detect a ribbon end. When a ribbon end is detected, “NO RIBBON” message will appear on the display and the ERROR LED will illuminate.
Ribbon |
Ribbon Sensor |
