Toshiba B-492L, R-TH10 owner manual 567, Feed key

APPENDIX 4 SYSTEM MODE	EO1-33032
	A4.5 Printer Parameter Fine Adjustment

A4.5 Printer Parameter	While in a Pause condition press and hold the [RESTART] key until
Fine Adjustment	“<0>RESET” appears in the display.
	￿￿!5(6(7
(Cont.)
NOTES:	Then, press the [FEED] key three times, and “<3>ADJUST SET” is
1. If the [FEED] and	displayed.
	￿￿!$'-8676(7
[RESTART] keys are
pressed at the same time in
the parameter setting, the
message returns to	Feed Length Fine Adjustment
“<3>ADJUST SET”.
2. If holding the [FEED] or
[RESTART] key for 0.5	With this parameter you can fine adjust position of the image on the
seconds or longer in the	media. With “<3>ADJUST SET” displayed, press the [PAUSE] key.
Printer Parameter Fine	)(('$'-￿￿￿￿￿PP		￿P
Adjustment, the key will
auto repeat.
3. A changed parameter
becomes enabled by
pressing the [PAUSE] key
4. Use the [FEED] or the	[RESTART]
[RESTART] key to change			PP
to a desired value or
option.
	[FEED]	)(('$'-￿￿￿￿￿￿PP

Feed Length Fine Adjustment (Example)

[FEED] key:	Pressing the [FEED] key once causes a –0.5mm
	change, down to –50.0 mm.

[RESTART] key: Pressing the [RESTART] key once causes a +0.5mm change, up to +50.0 mm.

After completing the fine adjustment, press the [PAUSE] key.

NOTE:

The fine adjustment value equals the sum of the fine adjustment values set by the PC command and this parameter. The maximum feed length fine adjustment value is ±50.0mm. When the addition of values reaches the maximum, the value remains unchanged even if subsequent fine adjustments are made.

A4- 7