Select the ribbon type
Print out the Maintenance Counter and Parameter Settings.
Perform a Self-Diagnostic Test, and prints out the result.
Check to see if there is any problem with the print head.

APPENDIX 4 SYSTEM MODE

EO1-33032

A4.3 Reset Mode

A4.3 Reset Mode

NOTE:

If the [RESTART] key is held for less than 3 seconds when the printer is in an error or pause state, the printer will restart printing. However, when a communication error or command error occurs, the printer will return to an idle condition.

A4.4 Self-Diagnostic Test

Outline of Self-Diagnostic Test

In the Self-Diagnostic Test mode, the printer checks and prints out the printer system information such as the sensor or interface, and the Maintenance Counter. It also performs the print head broken element check.

NOTE:

Use the [FEED] or [RESTART]

key to select a desired option.

The Reset operation clears all the print data that has been sent to the printer from the computer, and returns the printer to an idle condition.

1. The321printer$86(/,1(is on, standing￿￿by, or printing.

2. To ￿￿stop!5(6(7printing, or clear the data sent from the computer, press the [PAUSE] key. The printer stops printing.

3. Press21and/,1(hold the [RSTART] key for 3 seconds or longer.

4. Press [PAUSE] key. All data that has been received sent from the computer￿￿!',will$*￿be 9[cleared,￿[and the printer returns to an idle condition.

The Self5,%%21-Diagnostic75$16Test￿contains the following sub menus:

0$$872,17(1[PAUSE]',$$*11267,&(&217&￿

[PAUSE]

+([FEED]$'&+(&.[RESTART]

[FEED] [RESTART]

[FEED] [RESTART]

A4- 3

Page 53
Image 53
Toshiba B-492L, R-TH10 owner manual A4.3 Reset Mode, A4.4 Self-Diagnostic Test