Toshiba RAV-SM1100AT-E, RAV-SM1400AT-E ‡ Compressor Perform works of items 1 ‚, ƒ, „, …

No. Part name		Procedure	Remarks
‡ Compressor	1)	Perform works of items 1 of • and
		‚, ƒ, „, ….	Partition plate
	2)	Discharge refrigerant gas.
	3)	Remove the partition plate.
		(ST1T Ø4 x 10L, 2 pcs.)

4)Remove the noise-insulator.

5)Remove the terminal covers of the compressor, and disconnect lead wires of the compressor and the compressor thermo assembly from the terminal.

6)Remove pipes connected to the compressor with a burner.

	Compressor
	lead
CAUTION
Pay attention to that flame does not	Case thermo
involve 4-way valve or PMV. (If doing
so, a malfunction may be caused.)

7)Take off the fixing screws of the bottom plate and heat exchanger.

	(ST1T Ø4 x 10L, 2 pcs.)		Heat exchanger
8)	Take off the fixing screws of the valve	Remove
	clamping plate to the bottom plate.
9)	Pull upward he refrigerating cycle.	(Discharge pipe)
10) Take off nut fixing the compressor		Remove
	to the bottom place.		Screw
		(Suction pipe)
	CAUTION		Valve
			support board
When reconnecting the lead wires to			Screws (2 pcs.)
the compressor terminals after			Compressor bolt (3 pcs.)
replacement of the compressor, be
sure to caulk the Faston terminal
without loosening.

ˆ Reactor	1)	Perform works of item 1 of • and ƒ.
	2)	First take off two screws (ST1T Ø4 x		Partition	Reactor
		10L) of the reactor fixed to the reactor	Reactor	plate
					support board
		support.
	3)	Remove the reactor support from the
		partition plate.
		(ST1T Ø4 x 10L, 4 pcs.)
	4)	Take off two screws (ST1T Ø4 x 10L)
		directly attached to the partition plate.

96