Toshiba RAV-SM561BT-E, RAV-SM1400AT-E, RAV-SM1101BT-E Manual setting from remote controller

13-3. Address Setup

In case that addresses of the indoor units will be determined prior to piping work after cabling work

(Manual setting from remote controller)

<Address setup procedure>

•Set an indoor unit per a remote controller.

•Turn on power supply.

1	Push SET	+ +	buttons simultaneously
	for 4 seconds or more.
2	(← Line address) Using the temperature setup
	/	buttons, set 12 to the item code.
3	Using timer time		/ buttons, set the line address.
4	Push SET	button. (OK when display goes on.)
5	(← Indoor unit address) Using the temperature setup
	/	buttons, set 13 to the item code.
6	Using timer time		/ buttons, set 1 to the line address.
7	Push SET	button. (OK when display goes on.)
8	(← Group address) Using the temperature setup
	/	buttons, set 14 to the item code.

9 Using timer time / buttons, set 0000 to Individual, 0001 to Master unit, and 0002 to sub unit.

10 Push SET button. (OK when display goes on.)

11 Push button.

Setup completes.

(The status returns to the usual stop status.)

(Example of 2-lines cabling)

(Real line: Cabling, Broken line: Refrigerant pipe)

OUT OUT

	IN		IN
Line address		2
	1
Indoor unit address	1	1
Group address	1	2

For the above example, perform setting by connecting singly the wired remote controller without remote controller inter-unit cable.

Group address
Individual	: 0000
Master unit : 0001		In case of group control
Sub unit	: 0002

SET DATA

UNIT No.

R.C. No.

3, 6, 9

END11

1	UNIT
	SET CL

4, 7, 10

<Operation procedure>

2, 5, 8

1 2 3 4 5 6 7 8 9 10 11 END

86