Toshiba RAV-SM1101BT-E 1 2 3, <Contents>, <Procedure>, nCall of sensor temperature display

12-1-4. Monitor Function of Remote Controller Switch

nCall of sensor temperature display

<Contents>

Each sensor temperature of the remote controller, indoor unit, and outdoor unit can become known by calling the service monitor mode from the remote controller.

SET DATA

UNIT No.

R.C. No.

<Procedure>

1 Push + buttons simultaneously for 4 seconds or more to call the service monitor mode.

The service monitor goes on, the master indoor unit No. is displayed, and then temperature of the item code 00 is displayed.

2 Push the temperature setup / buttons to select the sensor No. (Item code) of the sensor to be monitored.

The sensor numbers are described below:

4

UNIT 2

SET CL

1 3

<Operation procedure>

1 2 3 4

Returned to usual display

	Item code	Data name		Item code	Data name
	00	Room temp (under control) *1		60	Heat exchanger temp TE
				61	Outside temp TO
Indoor	01	Room temp (remote controller)	Outdoor
				62	Discharge temp TD
	02	Indoor suction temp
unit data			unit data
				63	Suction temp TS
	03	Indoor coil temp (TCJ)
				64	—
	04	Indoor coil temp (TC)
				65	Heat sink temp THS

*1 Only master unit in group control

3 The temperature of indoor units and outdoor unit in a group control can be monitored by pushing button to select the indoor unit to be monitored.

4 Pushing button returns the display to usual display.

77