Toshiba RAV-SM1100AT-E, RAV-SM1400AT-E, RAV-SM1101BT-E, RAV-SM1401BT-E, RAV-SM561BT-E 108

No.	Part name		Procedure	Remarks
„ Inverter		1) Perform the works in 1 of • and ƒ.		Inverter assembly	Cycle P.C. board
	assembly	2) Remove connectors which are connected
			from the cycle P.C. board to other parts.
			CN600: TD sensor (3P: White)
			CN601: TO sensor (2P: White)
			CN604: TE sensor (2P: White) *(Note 1)
			CN605: TS sensor (3P: White) *(Note 1)
			CN301: Upper outdoor fan (3P: White)
			*(Note 1)
			CN300: Detection of upper position
			(5P: White)
			CN303: Lower outdoor fan (3P: White)
			*(Note 1)
			CN302: Detection of lower position
			(5P: White)
			CN500: Case thermo. (2P: White)
			*(Note 1)
			CN700: 4-way valve (3P: Yellow)	Hooks of heat sink cover
			*(Note 1)
				(2 positions)
			CN702: PMV (Pulse Motor Valve) coil		Inverter assembly
			(6P: White)
			Relay connector:
			Reactor 2 pcs. (3P: White) *(Note 1)
			Compressor lead: Remove terminal cover
			of the compressor, and remove the lead
			wire from terminal of the compressor.
		*(Note 1)
		Remove the connectors by releasing lock of
		the housing.
		3) Remove various lead wires from the
			holder at upper part of the inverter.
		4)	Cut off tie lap which fixes various lead
			wires to the inverter assembly.
		5)	Lift up the hook (upper left) with the	Heat sink cover
			partition plate upward just removing.

*Caution to mount the inverter assembly

Mount the inverter assembly to the partition plate so that hooks of the heat sink cover do not come near the partition plate but also near the fan side.

108