Toshiba RAV-SM1400AT-E, RAV-SM1101BT-E, RAV-SM1100AT-E, RAV-SM1401BT-E service manual 112, Detachment

No.

ˆ

‰

Part name		Procedure	Remarks
Compressor	1) Recover refrigerant gas.
	2)	Perform the works in 1 of • and in ƒ.
	3)	Remove the piping panel (Front).
		Take off screws of the piping panel (Front)
		and the base plate.
		(ST1T Ø4 × 10, 2 pcs)
		Take off screws of the piping panel (Front)
		and the piping panel (Rear).
		(ST1T Ø4 × 10, 2 pcs)
	4)	Remove the piping panel (Rear).
		Take off screws of the piping panel (Rear)	Piping panel (Front)
		and the base plate.
		(ST1T Ø4 × 10, 2 pcs)

5)Remove the sound-insulation plate.

6)Remove terminal cover of the compressor, and then remove compressor lead and case thermo. of the compressor.

(ST1T Ø4 × 10, 2 pcs)

7)Remove TD sensor fixed to the discharge

	pipe.
8) Using a burner, remove pipe connected to			Piping panel
	the compressor.		(Rear)
		Remove (Suction pipe)
	NOTE)
			Remove (Discharge pipe)
	Pay attention that 4-way valve or PMV is
		TD sensor	Case thermo.
	not exposed to a flame.
	(Otherwise, a malfunction may be caused.)

9) Pull out discharge pipe and suction pipe of the refrigerating cycle upward.

10) Take off the compressor nuts (3 pcs) fixing the compressor to the base plate.

11) Draw out the compressor toward you.

Compressor lead	Compressor nuts
	(3 pcs)

PMV coil	1. Detachment		Positioning extrusion	PMV body
	1)	Perform the works in 1 of • and in ƒ.
	2)	Hold outside of the coil by hands and turn
		it while lifting upward. The fixing hooks
		come off the fixing concavities and then
		the coil can be removed from PMV body.
	2. Attachment
	1)	Match the positioning extrusion of the coil
		surely to the concave part of PMV body,
		and then fix it.
			PMV coil	Concave part

112