Toshiba RAV-SM1400AT-E, RAV-SM1101BT-E <Heat>, Item, Outline of specifications, Remarks

No.	Item		Outline of specifications			Remarks
5	Air speed	<HEAT>
	selection
	(Continued)		Ta (˚C)
		(-0.5) –1.0		L(L)	E
				L(H)
		(0)	Tsh
				H(H)
		(+0.5) +1.0
				H	D
		(+1.0) +2.0		(HH)
				HH	C
		(+1.5)	+3.0
				(HH)	B
		(+2.0) +4.0
					A

Value in the parentheses indicates one when thermostat of the remote controller works.

Value without parentheses indicates one when thermostat of the body works.

•If the air speed has been changed once, it is not changed for 1 minute. However when the air speed is exchanged, the air speed changes.

•When heating operation has started, the air speed selects a upward slope, that is, the high position.

•If the temperature is just on the difference boundary, the air speed does not change.

•Mode in the parentheses indicates one in automatic heating operation.

•In Tc ≥ 60°C, the air speed increases by 1 step.

3) In heating operation, the mode changes to [UL] if		[PRE-HEAT] display
	thermostat is turned off.
4) If Ta ≥ 25°C when heating operation has started and		Tc	F5	F4
	when defrost operation has been cleared, it operates
	with HIGH (H) mode or (HH) for 1 minute from when Tc	(˚C)
	has entered in E zone of cool air discharge preventive	47
	control (Item 6).
5)	In automatic cooling/heating operation, the revolution
	frequency of [HH] is set larger than that in the standard	42
	cooling/heating operation. However the revolution		F5
	frequency is restricted in the automatic heating opera-
	tion as shown in the following figure.

6 Cool air	1) In heating operation, the indoor fan is controlled based	In D or E zone, the priority
discharge	on the detected temperature of Tc sensor or Tcj sensor.	is given to setup of air
preventive	As shown below, the upper limit of the revolution	volume exchange.
control	frequency is determined.	In A and B zones,
		[PRE-HEAT] is displayed.

Tc	(˚C)
Tcj		HH
	32
		H
	30
		L	E zone
	28
		UL	D zone
	26
	20	OFF	C zone
			B zone
	16
			A zone

34