Operating Basics
Set Up Procedure
Please use the following procedure when first using fingerprint authentication.
Fingerprint Registration
Enroll the required authentication data using the "OmniPass Enrollment Wizard".
The fingerprint authentication uses the same Windows logon ID and password. If the Windows logon password has not been setup, please do so before registration.
1.Click start, Point to All Programs, point to Softex and click OmniPass Enrollment Wizard.
2.Click Enroll.
3.The Verify Username and Password screen is displayed. Ensure the same Windows logon username and domain (*) are displayed before entering a password into the Password field. Click Next.
(*)If the Windows logon account is for use within a LAN domain, enter the domain name, otherwise, if you are unsure, please check with the network administrator. If the logon is not used within a LAN domain, you should just enter the computer name.
4.The Choose Finger screen is displayed. Based on the illustration, select the finger to be recognized, and then click Next. Previously enrolled fingerprints would have green check marks. The fingerprint being enrolled now would have a red check mark. If any of the previously enrolled fingerprints is selected again, the latest information will be enrolled and previous information
We recommend
5.The Capture Fingerprint screen is displayed. Follow the onscreen instructions and use the same finger you have selected under Choose Finger to swipe three times to allow the sensor to read the fingerprint. The fingerprint will be shown in green if properly read, or in red if the reading is abnormal.
6.The Verify Fingerprint screen is displayed. Swipe the finger again to allow the sensor to read again. When the Verification Successful message is displayed, click Next.
In case of finger injury or authentication failure, it is recommended that another fingerprint also be enrolled. The following message will be displayed:
"It is recommended that you enroll at least two fingers. Would you like to enroll an additional finger now?"
Click Yes and repeat steps 3, 4 and 5 with another finger.
7.The Audio and Taskbar Settings screen is displayed. Click Next. The Congratulations screen is displayed. Click Done.
User’s Manual |
