Operating Basics
Changing Ultra Slim Bay modules
This section explains how to change modules in the Ultra Slim Bay. The illustrations show replacement of the optical media drive with the Ultra Slim Bay HDD adaptor. Therefore, the text refers to those modules. However, the procedures are the same for any of the modules:
To avoid injury, do not put your hand into the Ultra Slim Bay slot.
The TOSHIBA Mobile Extension is preinstalled to support hot swapping under Windows. Refer to Chapter 1, Introduction for information on using this utility to change modules while the computer’s power is on.
Removing a module
Remove the optical media drive as described below.
1.You can confirm that the disks are not operating with indicators. If all indicators are off, it means that no disks are operating currently.
2.Turn the computer upside down.
Wait for all disk indicators to go out before you turn over the computer and do not lay the computer down gently. Shock can damage the HDD or other components.
3.Remove the screw near the icon securing the Ultra Slim Bay.
4.Make sure the screw in the Ultra Slim Bay lock screw is set in the hole for the unlock position.
5.Slide the Ultra Slim Bay latch to the unlock position.
6.Grasp the optical media drive and slide it out.
The optical media drive and other Ultra Slim Bay modules can become hot with use. Be careful when removing the module.
Lock screw
Ultra Slim Bay latch
Optical media drive
Figure 4-4 Removing the optical media drive
User’s Manual |
