Xerox 4520mp 0102†, Both Cards Out, Replace Original, Card Err. both, Power Off & On, Comm. Error

D i s p l a y e d C o n t r o l P a n e l M e s s a g e s

Figure 7.2	Control Panel messages (continued)
Message	Description/Action
0102†	SIMM in slot 2 has failed.

†Appears in the top left ACTION: Move the SIMM to another slot; see “Installing a SIMM” (page 5-5). If a

side of the display.	memory error (0100 or 0101) occurs again, replace the SIMM. If there is no error,
Indicates which module
	the main controller board has failed. Contact your dealer or Xerox / Rank Xerox.
failed.
Both Cards Out	Upper and lower font cards were removed while the printer was offline, but the
Replace Original	cards were still being used by the software application.
	ACTION: To clear the error message and resume printing, reseat the cards. Press
	Online	On completion of the print job, you can take the printer offline and
	remove the cards.
Card Err. both	Both the upper and lower font cards were removed while the printer was online.
Power Off & On	ACTION: Power OFF the printer, then power it ON to resume.
Close HCEF Cover	The printer’s High-Capacity Envelope Feeder (HCEF) cover is open or the HCEF is
	not ready. Check all connections.
	ACTION: Close the cover, and press Online			to resume normal operation.
Close HCF Cover	The printers’s High-Capacity Feeder (HCF) cover is open or the HCF is not ready.
	Check all connections.
	ACTION: Close the cover, and press Online			to resume normal operation.
Close Top Cover	The top cover is open.
	ACTION: Close it, and press Online		to resume normal operation.
Comm. Error	If your printer is configured for serial, a framing or parity error has occurred on the
	serial interface.
	ACTION: You have a mismatch between your printer and the host. Check your
	printer serial configuration (baud rate, handshake, parity, etc.) to be certain the
	serial settings match your host (page 3-46). If problem persists, contact your dealer
	or Xerox / Rank Xerox.
	If your printer is configured for parallel, the printer is not able to communicate
	with the host using bidirectional parallel.
	ACTION: Check the parallel cable to make sure it is connected properly on both
	the printer and the host. Inspect the parallel cable for any defects; if wires are
	broken or the cable appears to be damaged, replace the cable. Check the host to
	be certain that it is configured properly. Under the Parallel Menu, turn
	Bidirectional Off. If problem persists, contact your dealer or Xerox / Rank Xerox.
Comm. Error:nn	A LocalTalk error has occurred. nn is the AppleTalk error number.

7-6❖ 4 5 2 0 / 4 5 2 0 m p U s e r ’ s G u i d e