Xerox 4520mp manual Option Setting Description

		P o s t S c r i p t M e n u
Figure 3.10 PostScript Menu options showing factory settings
Option	Setting	Description
Copies	1* - 99	Number of times each page is printed.
		Most software applications override this setting. If
		your application does not, the printer assumes the
		default setting here.
Default Tray	Upper*	Paper tray used if none is specified in your software
	Middle	application.
	Lower
	Manual
	HCF†
	HCEF†
	† Appears only when the
	option is installed.
Tray Switching	Off	Sequence of trays the printer uses when printing a
	Upper-Middle	page of a PostScript print job.
Note: The default for Tray	Upper-Lower	If the tray requested for the page is included in this
	Middle-Lower
Switching is Up-Mid-Low		sequence then the whole sequence is used instead of
or HCF-Up-Mid-Low for	Up-Mid-Low
		the requested tray, the first tray used is the first one in
firmware releases < 4.06.	HCEF-Upper†
		the sequence, going from left to right, that satisfies all
The default is Off (as	HCEF-Middle†
		page requirements. If the requested tray is not
shown at right) for releases	HCEF-Lower†
4.06 and higher. To		included in this sequence then the requested tray
	HCEF-Up-Mid†
determine the firmware		alone is used. For example if this setting is
release of your printer,	HCEF-Up-Low†
		“Upper-Lower” and the lower tray is requested then
print a Configuration	HCEF-Mid-Low†
		the upper tray will be used first provided that it
Sheet.	HCEF-Up-Mid-Low†
		contains the requested size of paper.
	HCF-Upper†
		When this sequence is being used and the current tray
	HCF-Middle†
	HCF-Lower†	runs out of paper then the next tray in the sequence
	HCF-Up-Mid†	that has the same size paper will be used.
	HCF-Up-Low†	Settings that begin with HCEF only appear when a
	HCF-Mid-Low†
		High Capacity Envelope Feeder is installed.
	HCF-Up-Mid-Low†
		Settings that begin with HCF only appear when a
		High Capacity Feeder is installed.
		The factory default is HCF-Up-Mid-Low when an HCF
		is installed or Up-Mid-Low when an HCF is not
		installed.
	† Appears only when the	PostScript drivers other than the Xerox driver may
		simply enable or disable Tray Switching; they can
	option is installed.	not specify a setting.

C h a p t e r 3 : U s i n g t h e C o n t r o l P a n e l ❖ 3-33