Xerox 4520mp manual Source Mapping Settings, Source Mapping Description Setting

Source Mapping Settings

S e l e c t i n g a P a p e r S o u r c e

For each of the six PCL paper sources (Figure 2.16,

page 2-30), a Source Mapping setting from Figure 2.17 is used. You may change settings depending on your printing needs. For details, see “Factory-Set Source Mapping Settings” (page 2-35), “Source Mapping Examples” (page 2-36), and Source Mapping (page 3-22).

Figure 2.17	Source Mapping settings
Source Mapping		Description
setting
Upper		Tray or tray sequence to be used for each
Middle		of the six PCL paper sources.
Lower
Upper-Middle
Upper-Lower
Middle-Lower
Up-Mid-Low
Manual		Tray selection appearing when there is no
		MBF, HCF, or HCEF installed.
		Use this selection to print the first page
		of a print job by feeding a single sheet of
		paper into the SBF slot before the print
		job starts.
MBF		Tray selection appearing when the MBF
		(page 2-14) is installed.

C h a p t e r 2 : H a n d l i n g P a p e r ❖ 2-33