Xerox 4520mp manual Source Mapping Examples

S e l e c t i n g a P a p e r S o u r c e

Source Mapping Examples

Review the following Source Mapping examples to take full advantage of the 4520/4520mp capabilities.

All examples assume that Default Source is set to Upper.

Example 1	You do not have a MBF or HCF installed. You want to load as
	much paper in the printer as possible. You use only one size
	of paper.
	1. Load the upper, middle, and lower trays with regular
	paper stock.
	2. Set Source Mapping for “Upper” to “Up-Mid-Low.”
	3. In either your software application or the Xerox printer
	driver, set paper source to the upper tray.
	The printer will pull paper from the upper tray until is it
	empty, then from the middle tray until it is empty, and then
	from the lower tray until it is empty. As soon as the upper or
	middle tray is reloaded, the printer will pull paper from them
	again.
	The Source Mapping setting determines from where the
	printer pulls paper.
Note	For the paper sources you intend not to use, always set Source
	Mapping to the same setting as that used for your regular
	paper stock. You will avoid unexpected results if those paper
	sources are used by mistake.

The examples suggest using specific PCL paper sources but generally you may substitute any source to fit your printing needs.

Note

2-36❖ 4 5 2 0 / 4 5 2 0 m p U s e r ’ s G u i d e