Xerox 4520mp manual Point Size, 12.00, Interaction of Default Source and Source Mapping

P C L M e n u

Figure 3.8 PCL Menu options showing factory settings (continued)

Option	Setting	Description
Point Size	4.00 - 999.75 by .25	Point size (a measurement for type height, 1 point
	(12.00*)	equals 0.351 mm or approximately 1/72 inch) for the
		font represented by Font Number (page 3-20).
		Appears only when the Font Number setting
		specifies a scalable proportional spaced font, such as
		Times New Roman.
		Most software applications override this setting. If
		your application does not, the printer assumes the
		default setting here.
Default Source	Upper*	Default paper source in PCL if none is specified by
	Manual	your software application.
	Manual Envelope	The printer uses Default Source when there is no
	Lower
		paper source specified in the print job. Some software
	Large Capacity†
		applications have a paper source selection called
	Envelope Feeder†
		“Auto Select” or “Auto Sheet Feed” which usually
		results in the omission of a paper source selection in a
		print job.
		When the printer uses Default Source, Source
	† Appears only when the	Mapping (page 3-22) is used to determine the actual
		tray or slot from which the printer pulls paper. See
	HCF (for Large Capacity)	Chapter 2: Handling Paper, “Selecting a Paper
	or HCEF (for Envelope
		Source” (page 2-30)for more information on the
	Feeder) option is installed.
		interaction of Default Source and Source Mapping.

C h a p t e r 3 : U s i n g t h e C o n t r o l P a n e l ❖ 3-21