Installation and Setup

Loading the Transfer Film

Step 2. Unroll about one foot from the full roll of transfer film (supply spool), and wind it (2 wraps) onto the empty take-up spool.

Step 3. Load transfer film supply spool onto the supply spindles, green flange side to the left.

Step 4. Load the empty take-up spool onto the take-up spindles, white flange side to the right.

Step 5. Make sure the spring-loaded spindles on the right seat into the spools.

Step 6. Make sure the transfer film comes off the bottom of the supply spool and feeds to the bottom of the take-up spool.

Step 7. The figure below shows the proper installation of the transfer film.

Zebra ZXP Series 8 Card Printer with Laminator

P1013372-001 Rev. A