Installation and Setup

Installing the Cleaning Roller

Installing the Cleaning Roller

The Cleaning Roller cleans the cards entering the Printer from either the Input Hopper or the Single-Feed Input.

Step 1. Remove the Cleaning Roller from its packaging. To avoid contamination, always hold the roller by the ends.

Step 2. Peel the protective wrapper from the Cleaning Roller.

Step 3. Open the Printer Door by pressing the Door Release button on the top of the Printer. Step 4. Locate the area where the Cleaning Roller will be installed; circled below.

Step 5.

Hold the Cleaning Roller by the ends.

Step 6.

Position the ends of the Cleaning Roller in the slots.

Step 7.

Push down until the roller fully seats and latches.

Step 8.

Close the Printer’s Door.

14

Zebra ZXP Series 8 Card Printer with Laminator

P1013372-001 Rev. A

Page 18
Image 18
Zebra Technologies P1013372-001 REV. A user manual Installing the Cleaning Roller, Step Close the Printer’s Door