ZXP Series Toolbox
Cleaning
Clean Laminator
The Clean Laminator screen gives you the option to clean the laminator via the Toolbox; refer to Section 6, for cleaning via the OCP.
•Card transport Rollers
When you click on the Clean button, instructions will appear in the following sequence:
1.Open the laminator cover, remove the laminate (top and bottom cassettes), and close the cover. Then, click Ok.
2.Wait until the laminator temperature goes below 60o.
3.Remove the card hopper, and click Ok.
4.Insert the Laminator Cleaning Card in the side slot where the card hopper was located. Click Ok after inserting the cleaning card.
5.Wait until the cleaning process completes. The card will eject through the laminator side slot.
6.Observe the message, Laminator cleaning successful.
7.Open the laminator cover, install the laminate (top and bottom spools), and close the cover.
•Heater Rollers (see Cleaning: Heater Assembly Rollers section on page 114).
98 | Zebra ZXP Series 8 Card Printer with Laminator |
