Zebra Technologies P1013372-001 REV. A user manual Temperature and Position Settings

ZXP Series Toolbox

Configuration

•Temperature and Position Settings

-Transfer Temperature Offset:

Note • While you will not see a change in card parameters for a given card type when using the Transfer Temperature Offsets, you will see the change in the OCP Info screen that shows the temperature set-points and current temperatures.

Transfer Temperature Offset is provided to globally change the temperature of the heated rollers. If you have a single card type that you want to change the roller temperatures, you would use custom card type. If the printer seems to be running too cold or too hot for every card type, you would use this adjustment to raise or lower the heated roller temperature for all cards. This will not affect what you see in the card parameters for a given defined card type; see Note above. The adjustment range is: Minimum -10, Maximum 10.

-Print Position:

Film print X offset (dots): This is the number of dots (300 dpi / ~3 mils/dot.) to shift the image to align it on the card. Increasing these values move the image right while decreasing them moves the image left. This parameter can be used to center the image on the card, or to align it with an edge. The adjustment range is: Minimum -50, Maximum 50.

Film print Y offset (mils): This is the number of mils to shift the image to align it on the card. Increasing these values moves the image up while decreasing them moves the image down. This parameter can be used to center the image on the card, or to align it with an edge. The adjustment range is: Minimum -100, Maximum 100.

The Save Settings button saves any changes you have made to this screen.

The Advanced Setting button provides access to service-related tests and adjustments. Use is password protected and limited to Zebra-authorized service personnel.

P1013372-001 Rev. A Zebra ZXP Series 8 Card Printer with Laminator 95