Installation and Setup
Connecting Power
Connecting Power
Electric Shock Caution • Limit AC power supplied to the Printer to 100 – 230 volts,
60 ~ 50 Hertz. Limit excess current draw to 16 amps or less, using an associated circuit breaker or other such device.
Never operate the Printer in a location where operator, computer, or printer can get wet. Personal injury could result.
The Printer must be connected to an earthed electrical power source and properly protected against electrical surges and grounding faults; the electrical reliability of the Printer is based on the reliability of the mains power source and with the earth connection.
The Printer’s power supply is an internal unit that can only be serviced or replaced by trained and authorized personnel.
1 |
|
✓ | 2 |
Step 1. Place the Printer’s power switch in the OFF ( 
) position.
Step 2. Depending on your local AC voltage, plug the appropriate power cord into the Printer’s power connector and a grounded AC power source connection.
DO NOT SWITCH THE PRINTER ON (
).
Zebra ZXP Series 8 Card Printer with Laminator | 31 |
